Technical information are provided for informative purpose only and can be subject to change without prior notice 98 Automotive Catalogue Clamping Series Caution Any maintenance operation may only be carried out by qualified and authorized personnel. For any reason, do not reach into the pivoting range of the clamping arms, when the clamps are in operation. Disconnect and lock out pneumatic and electric supply lines before operating on or around clamps. Functional description When operated, the pneumatic cylinder acts on an integrated toggle mechanism, which triggers the pivoting movement of the clamping arms. Clamp installation to the tool The clamp can be installed by one of its four mounting surfaces, using dowels and screws according to its datasheet. The tightening torques to be set are: M5 5 N m / 3.68 lb·ft M6 10 N m / 7.37 lb·ft M8 25 N m / 18.43 lb·ft M10 35 N m / 25.81 lb·ft M12 50 N m / 36.87 lb·ft Use the key support surfaces, where available. Always use all the bores on the mounting pattern. A worksheet for the right sizing of the clamp is available upon request. Visit our website for technical documents The clamp is warranted for 3 mln cycles in correct operating conditions No lubrication. No preventive maintenance. External cleaning with non-corrosive detergents is required: cleaning interval depends on the ambient conditions as well as on the frequency of use. 3 MLN CYCLES QIG_C_EN Rev.00 09.2015 Pressure operating range: from 2 to 8 bar/ from 30 to 115 psi. Inline lubrication isn’t required: if lubricated air is used, it is necessary to continue using lubricated air, as the oil in it may have removed the basic lubrication in the device. http://automotive.pneumax.it/ Electronic sensor ES001 is used for all clamps’ sizes and series. Adjustment of the connector: unscrew the tightening screw and set the connector in the required position, then secure the screw with 5 N m / 3.68 lb·ft. To replace the sensor, remove the M5 screw and assemble a new one by tightening the same screw with 5 N m / 3.68 lb·ft. Technical features Operating voltage 10-30 VDC Voltage drop ≤ 2 V Load current ≤ 100 mA Current consumption ≤ 30 mA Short-circuit protection protected Protection rating IP68 Operating temperature –0 °C +50 °C Storage temperature –25 °C +60 °C Electromagnetic compatibility EN 60947-5-2:2007 + A1:2012 Power supply indication green LED Open position indication yellow LED Closed position indication red LED Digital output type PNP 1 4 3 2 Semplified diagram (PNP) Open Close Not engaged Yellow Green Brown + Black Blue White LOAD LOAD Red Engaged Clamping Quick installation guide CLAMPING
RkJQdWJsaXNoZXIy NzYzOTY1