Technical information are provided for informative purpose only and can be subject to change without prior notice 99 Automotive Catalogue Clamping Series CLAMPING Clamping arm mount The sides of the brackets have two different heights. Assemble the brackets to the side of the clamping arm, so that the surfaces, where the side mark has been machined on, will match. Secure, at first, the screw on the mark side 1 by setting the tightening torques indicated on the clamping arm datasheet, and leave no gap between the bracket and the arm. Then, secure the other screw 2 : in this case, due to the different length of the sides of the brackets, a gap between the same and the clamping arm will be noticed. Always use locking washers. Handles with knobs for manual levers RK7100/0015 Handle with green knob and bracket; D2 version for 25 and 32 mm bore clamps and manual pin packages RD250 and FD63 RK7100/0005 Handle with green knob and bracket; D1 version for 40 mm bore clamps RK7100/0006 Handle with green knob and bracket; D2 version for 40 mm bore clamps RK7100/0003 Handle with green knob and bracket; D1 version for 50 and 63 mm bore clamps RK7100/0004 Handle with green knob and bracket; D2 version for 50 and 63 mm bore clamps RK7100/0007 Handle with green knob and bracket; D2 version for 80 mm bore clamps The levers’ kits include handle knob, bracket and M5 x 16 screws. Tightening torque: 5 N m/ 3.68 lb·ft. The handles can be installed on the left or on the right side of the clamps- all manual clamps show a dual output shaft. 1 2 Arm mount options 1 Position 2 Position 3 Position 4 Position The above pictures show the closed position. The max. opening angle according to the arm mount option is indicated on each clamp arm’s datasheet. In order to achieve a right or left arm mount in configurations 2 or 3, the clamping arm should be rotated by 180°, therefore to achieve C1P/HE1P___ 2A03 a right clamp arm is required, i.e. B/Q _ _02 C1P/HE1P___ 2A02 a left clamp arm is required, i.e. B/Q _ _03 C1P/HE1P___ 2A05 a right clamp arm is required, i.e. B/Q_ _06 C1P/HE1P___ 2A06 a left clamp arm is required, i.e. B/Q_ _05 C1_ _ _ _2A03 using a right _ _02 arm C1_ _ _ _2A02 using a left _ _03 arm Match the bracket’s side with the arm side which shows a mark
RkJQdWJsaXNoZXIy NzYzOTY1