AUTOMOTIVE CATALOGUE 2024

Technical information are provided for informative purpose only and can be subject to change without prior notice 154 HANDLING Automotive Catalogue Clamping jaws mount The sides of the brackets have two different heights. Assemble the brackets to the side of the clamping arm, so that the surfaces, where the side mark has been machined on, will match. Secure, at first, the screw on the mark side 1 by setting the tightening torques to 22 N m /16.22 lb·ft and leave no gap between the bracket and the jaws. Then, secure the other screw 2 : in this case, due to the different length of the sides of the brackets, a gap between the same and the clamping arm will be noticed. Always use locking washers. Please refer to the clamping arms’ datasheet for possible clamping arm position and the respective max opening angle. Caution Any maintenance operation may only be carried out by qualified and authorized personnel. For any reason, do not reach into the pivoting range of the clamping arms, when the clamps are in operation. Disconnect and lock out pneumatic and electric supply lines before operating on or around clamps. Clamp installation to the tool The gripper clamp can be installed by one of its four mounting surfaces, using dowels and screws according to its datasheet. The tightening torques to be set are: M6 10 N m / 7.37 lb·ft Use the key support surfaces, where available. Always use all the bores on the mounting pattern. The clamp is warranted for 3 mln cycles in correct operating conditions No lubrication. No preventive maintenance. External cleaning with non-corrosive detergents is required: cleaning interval depends on the ambient conditions as well as on the frequency of use. 1 2 A worksheet for the right sizing of the clamp is available upon request. Visit our website for technical documents 3 MLN CYCLES QIG_H_EN Rev.00 09.2015 Pressure operating range: from 2 to 8 bar/ from 30 to 115 psi. Inline lubrication isn’t required: if lubricated air is used, it is necessary to continue using lubricated air, as the oil in it may have removed the basic lubrication in the device. http://automotive.pneumax.it/ Handling Quick installation guide

RkJQdWJsaXNoZXIy NzYzOTY1