Technical information are provided for informative purpose only and can be subject to change without prior notice 161 HANDLING Automotive Catalogue Opening angle adjustment The jaws must be in the open position. Insert a 5 mm hexagonal flat Allen Wrench or a screw gun and adjust the opening position to the required opening angle. Electronic sensor ES001 is used for all clamps’ sizes and series. Stepless adjustment of the connector: unscrew the tightening screw and set the connector in the required position, then secure the screw with 5 N m / 3.68 lb·ft. Adjustment Of the tips Adjust the lower tips at a predetermined position and place the metal sheet to be held. For an optimal holding of the workpiece, adjust the tips on the mobile arm until contact with the workpiece is reached. Open and close the clamp. After a proper adjustment to get the required clamping force has been accomplished, secure the tip screws by tightening the bolts. Tips with different holding surfaces are available upon request. Manual release button To manually unlock the mechanism, hit the bolt with a rubber mallet. The linkage will automatically release itself from the over-centre position. To close the clamps during set-up operations, without air, use a screw gun or a flat Allen wrench to engage the adjustment means and adjust the clamp till 0° opening angle: the linkage will be togglelocked as the manual release button is completely outside. The J40D and the JK40D series are equipped with a handlever, with whom the clamp can be closed and opened. One access point to opening angle adjustment on each side Visit our website for a video of the adjustment procedure. No adjustment of the sensor is required. Technical features Operating voltage 10-30 VDC Voltage drop ≤ 2 V Load current ≤ 100 mA Current consumption ≤ 30 mA Short-circuit protection protected Protection rating IP68 Operating temperature –0 °C +50 °C Storage temperature –25 °C +60 °C Electromagnetic compatibility EN 60947-5-2:2007 + A1:2012 Power supply indication green LED Open position indication yellow LED Closed position indication red LED Digital output type PNP 1 4 3 2 Semplified diagram (PNP) Open Close Not engaged Yellow Green Brown + Black Blue White LOAD LOAD Red Engaged To replace the sensor, remove the M5 screw and assemble a new one by tightening the same screw with 5 N m / 3.68 lb·ft.
RkJQdWJsaXNoZXIy NzYzOTY1