Technical information are provided for informative purpose only and can be subject to change without prior notice 165 Electronic sensor ES001 is used for all power pivots’ sizes and and for the detection of the brake condition ( activated/ deactivated). Adjustment of the connector: unscrew the tightening screw and set the connector in the required position, then secure the screw with 5 N m / 3.68 lb·ft. Manual release mechanism of the linkage A manual override access to untoggle the linkage in case of emergency is provided for all power pivots. Before unlocking the mechanism, make sure not to reach into the swivel area of the saddle arm: once the linkage is untoggled, the arm can move quickly and abruptly in any direction. Make sure all safety requirements are met. Such operations must be carried out by qualified specialists. Pneumatic connection Recommended pneumatic scheme To replace the sensor, remove the M5 screw and assemble a new one. Technical features Operating voltage 10-30 VDC Voltage drop ≤ 2 V Load current ≤ 100 mA Current consumption ≤ 30 mA Short-circuit protection protected Protection rating IP68 Operating temperature –0 °C +50 °C Storage temperature –25 °C +60 °C Electromagnetic compatibility EN 60947-5-2:2007 + A1:2012 Power supply indication green LED Open position indication yellow LED Closed position indication red LED Digital output type PNP 1 4 3 2 Semplified diagram (PNP) Open Close Not engaged Yellow Green Brown + Black Blue White LOAD LOAD Red Engaged 1 2 4 3 Power pivot without brake Power pivot with brake system WARNING Automotive Catalogue PIVOTING
RkJQdWJsaXNoZXIy NzYzOTY1