Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice CAnopen® module 1 Air distribution Solenoid valves manifold ISO 15407-2 1 | 385 Series 2700 - Serial systems 2 1 3 4 2 1 4 3 5 1 2 5 4 3 Scheme / Overall dimensions and I/O layout : M12 5P MALE NETWORK connectors POWER SUPPLY connector M12 5P FEMALE M12 4P MALE Optional CAN external positive supply (Dedicated for supply of transceiver and Optocouplers, PIN SIGNAL DESCRIPTION 1 CAN_SHLD Optional CAN Shield 2 CAN_V+ 3 CAN_GND Ground / 0V / V4 CAN_H CAN_H bus line (dominant high) 5 CAN_L CAN_L bus line (dominant low) if galvanic isolation of the bus node applies) Technical characteristics General: ® CANopen module is directly integrated on 2700 solenoid valves manifold via a 37 poles connector, normally used for multipolar cable connection. 2700 series solenoid valves connected to node must be PNP equivalent (final 02 in ordering code). The node can be easily installed also on solenoid valves manifold already mounted on equipment. Module can manage up to 32 solenoid valves, and, in the same time, a max number of 4 Input modules 5225.08T or a max number of 4 Input modules 5225.12T. ® CANopen module recognizes automatically the presence of the Input modules on power on. Regardless of the number of Input modules connected, the managable solenoid valves are 32. Node power supply is made by a M12 4P male circular connector. The separation between node 24 VDC Power supply and outputs 24 VDC allows to switch off the outputs maintaning powered the node and inputs, if present. ® Connection to Bus CANopen is possible via 2 M12 5P male - female circular connectors; these two are connected in parallel and according to CiA Draft Recommendation 303-1 (V. 1.3 : 30 December 2004). Transmission speed can be set by 3 dip-switches. The node address can be set by 6 dip-switches using BCD numeration. The module includes an internal terminating resistance that can be activated by a dip-switch. Ordering code 5525.32T PIN DESCRIPTION 1 +24 VDC (NODE & INPUTS) 2 NC 3 GND 4 +24 VDC (OUTPUTS) 5525.32T CiA Draft Standard Proposal 301 V 4.10 (15 August 2006) Reinforced technopolymer M12 4P male connector (IEC 60947-5-2) +24 VDC +/- 10% 30 mA Green LED PWR +24 VDC +/- 10% 100 mA 32 32 10 - 20 - 50 - 125 - 250 - 500 - 800 - 1000 Kbit/s From 1 to 63 64 (slave + master) 100 m at 500 Kbit/s Green LED + Red LED Available from our web site: http://www.pneumaxspa.com IP65 when assembled From 0° to +50° C Model Specifications Case Power supply connection Power supply voltage Node consumption (without inputs) Power supply diagnosis PNP equivalent outputs Maximum current for each output Maximum output number Max output simultaneously actuated Network connectors Baud rate Addresses, possible numbers Max nodes in net Bus maximum recommended length Bus diagnosis Configuration file IP protection grade Temperature range 2 M12 5P connectors male-female Type A (IEC 60947-5-2) Power supply Outputs Network MAX 32 OUT 68 53 82
RkJQdWJsaXNoZXIy NzYzOTY1