Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice 1 Air distributiOn Solenoid valves manifold 1 | 519 Series 2300 ENOVA® - Serial systems ►CANopen® protocol node PIN 1 CAN_SHLD Optional CAN Shield 2 CAN_V+ Optional CAN external positive supply (Dedicated for supply of transceiver and Optocouplers, if galvanic isolation of the bus node applies) 3 CAN_GND 0 V 4 CAN_H CAN_H bus line (dominant high) 5 CAN_L CAN_L bus line (dominant low) 4 1 3 2 PIN 1 2 3 0 V 4 3 2 4 5 1 4 1 3 2 5 90 32.5 50 60 DESCRIPTION POWER SUPPLY connector M12A 4P MALE SIGNAL DESCRIPTION + 24 V DC (LOGICS AND INPUTS) + 24 V DC (OUTPUTS) NETWORK connectors M12A 5P FEMALE M12A 5P MALE MAX 22 OUT N.C. Technical characteristics Model 5523.22 specifications CiA 106 (V.1.1.0 : July 11th 2023) Case reinforced technopolymer Power supply Power supply connection M12 4P male connector Power supply voltage +24 VdC +/- 10% node consumption (without inputs) 25 mA Power supply diagnosis Green LEd PWr Outputs PnP equivalent outputs +24 VdC +/- 10% Max. current for output 100 mA Maximum output number 22 Max. output simultaneously actuated 22 network network connectors 2 M12 5P connectors male-female baud rate 10 - 20 - 50 - 125 - 250 - 500 - 800 - 1000 Kbit/s Addresses possible numbers From 1 to 63 Maximum nodes number in network 64 (slave + master) bus maximum recommended length 100 m at 500 Kbit/s bus diagnosis Green LEd + red LEd Configuration file Available from our web site http://www.pneumaxspa.com Protection degree iP65 when assembled temperature range From 0 °C to +50 °C Coding: 5523.22 CAnopen® node is directly integrated on Enova® solenoid valves manifold via a 25 poles connector, normally used for multi-pin cable connection. Enova® solenoid valves connected to node must be PnP equivalent (final 02 in ordering code). the node can be easily installed also on solenoid valves manifold already mounted on equipment. node can manage up to 22 solenoid valves, and, in the same time, a max number of 3 input modules 5200.08. CAnopen® node recognizes automatically the presence of the input modules on power on. regardless of the number of input modules connected, the managable solenoid valves are 22. node power supply is made by a M12 4P male circular connector. the separation between node 24 V dC Power supply and outputs 24 V dC allows to switch off the outputs maintaning powered the node and inputs, if present. Connection to bus CAnopen® is possible via 2 M12 5P male - female circular connectors; these two are connected in parallel and according to CiA 106 (V.1.1.0 : July 11th 2023). transmission speed can be set by 3 dip-switches. the node address can be set by 6 dip-switches using bCd numeration. the node includes an internal terminating resistance that can be activated by a dip-switch. Scheme / Overall dimensions and I/O layout
RkJQdWJsaXNoZXIy NzYzOTY1