Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Cylinders according to standard ISO 15552 Series 1319-1320-1321 3 Pneumatic actuation 3 | 41 Series 1319-1320-1321 This series of pneumatic cylinders is manufactured according to ISO 6431 standards adapted to VDMA 24562 and CNOMO/AFNOR 49003 that guarantee the interchangeability of the cylinders even without mounted anchoring. Construction characteristics Cushion bushings hardened aluminium Piston rod bushings self-lubricating sintered bronze Barrel oxidised aluminium Seals standard: NBR Oil resistant rubber, PUR Piston rod and cushion seals (FPM seals available upon request) Pistons vulcanized rubber block on steel core with incorporated plastoferrite permanent magnet, or without magnet for non magnetic version (plus rear spacer). Piston rod stainless steel or C43 chromed steel End caps from Ø32 to Ø125: UNI 5079 aluminium alloy casting painted black by cataphoresis from Ø160 to Ø200: UNI 3051 aluminium chilled painted black by cataphoresis Cushion adjustment screws brass Operational characteristics Fluid filtered and lubricated air Pressure max. 10 bar Working temperature -5 °C ... +70 °C with standard seals (magnetic or non magnetic piston) -5 °C ... +80 °C with FPM seals for 1319 and 1320 series (magnetic piston) -5 °C ... +150 °C with FPM seals for 1321 series (non magnetic piston) Cushioning lenght Ø 32 40 50 63 80 100 125 160 200 mm 28 32 32 40 44 50 55 55 55 Please follow the suggestions below to ensure a long life for these cylinders: • use clean and lubricated air. • correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. • avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device). • evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.). Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Standard strokes (for all diameters) Double acting version from 0 to 150, every 25 mm over 150 up to 500, every 50 mm over 500 up to 1000, every 100 mm On request are available strokes up to: 2800 mm Single acting version From 32 to 125, up to stroke 50 mm. On request are available strokes up to: 200 mm Stroke tolerance (ISO 15552) Bore Stroke Tolerance 32-40-50 up to 500 mm +2 0 over 500 up to 1000 +3,2 0 63-80-100 up to 500 mm +2,5 0 over 500 up to 1000 +4 0 125-160-200 up to 500 mm +4 0 over 500 up to 1000 +5 0 Minimum and maximum springs load (stroke 0 ... 50mm) Bore Ø32 Ø40 Ø50 - Ø63 Ø80 - Ø100 Ø125 Min. load (N) 15 25 50 100 150 Max. load (N) 40 80 115 200 250
RkJQdWJsaXNoZXIy NzYzOTY1