Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Cylinders according to standard ISO 15552 Series Ecoplus - High Performance 3 Pneumatic actuation 3 | 47 Series Ecoplus - High Performance Profiled tube has two "T" slots on the three sides hosting sensors 1580._, MRS._, MHS._. without adaptors. Construction characteristics Piston rod bushings self-lubricating sintered bronze Barrel anodised aluminium alloy Seals standard: NBR Oil resistant rubber, PUR Piston rod seals (PUR seals available upon request) Pistons acetal resin, aluminium on request Piston rod C43 chromed steel or stainless steel End caps Series 1386 ... 1388: high resistant thermoplastic material Series 1396 ... 1398: Die-cast aluminium Cushion adjustment screws brass Operational characteristics Fluid filtered and preferably lubricated air or not (if lubricated the lubrication must be continuous) Pressure max 10 bar Working temperature -5°C ... +70°C with standard seals -30°C ... +80°C with PUR seals Bore Ø 32 40 50 63 80 100 Cushioning lenght mm 27 31 31 37 40 44C cushioning lenght "K" and "PK" version mm 20 20 22 22 32 32 Please follow the suggestions below to ensure a long life for these cylinders: • use clean and lubricated air. • correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. • avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device). • evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.). Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Standard strokes (for all diameters) from 0 to 150, every 25 mm from 150 to 500, every 50 mm from 500 to 1000, every 100 mm On request are available strokes up to: 2800 mm Stroke tolerance (ISO 15552) Bore Stroke Tolerance 32-40-50 up to 500 mm +2 0 over 500 up to 1000 +3,2 0 63-80-100 up to 500 mm +2,5 0 over 500 up to 1000 +4 0
RkJQdWJsaXNoZXIy NzYzOTY1