Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Cylinders according to standard ISO 15552 3 | 46 Series 1386 - 1387 - 1388 - 1396 - 1397 - 1398 - ECOPLUS Pneumatic actuation 3 Profiled tube has two "T" slots on the three sides hosting sensors 1580._, MRS._, MHS._. without adaptors. Bore Tolerance Stroke up to 500 over 500 up to 1000 up to 500 over 500 up to 1000 +2 0 +3.2 0 +2.5 0 +4 0 32 - 40 - 50 63 - 80 - 100 Standard strokes (for all diameters) Stroke tolerance (ISO 15552) from 0 to 150, every 25 mm from 150 to 500, every 50 mm from 500 to 1000, every 100 Series 1386-1387-1388/ 1396/1397/1398, ECOPLUS General Construction characteristics Operational characteristics Series 1386 - 1388: high resistant thermoplastic material C43 chromed steel or stainless steel anodised aluminium alloy self-lubricating sintered bronze acetal resin, aluminium on request standard: NBR Oil resistant rubber, PUR Piston rod seals (PUR seals available upon request) brass Rod Barrel Rod-guide bushing Piston Seal Cushion adjusting screws Series 1396 - 1398: Die-casting aluminium End caps Ø 32 - 40 - 50 - 63 - 80 - 100 mm 27 - 31 - 31 - 37 - 40 - 44 Fluid Max. pressure Operating temperature -5°C - +70°C with standard seals -30°C - +80°C with PUR seals mm 20 - 20 - 22 - 22 - 32 - 32 Filtered air. No lubrication needed, if applied it shall be continuous. 10 bar Bore Cushioning lenght Cushioning lenght "K" and "PK" version Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod; •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device and aluminium piston); •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Our Technical Department will be glad to help. On request are available strokes up to 2800 mm
RkJQdWJsaXNoZXIy NzYzOTY1