Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Compact cylinders according to standard ISO 21287 3 | 87 Series 1500 Ecompact 3 Pneumatic actuation General These cylinders are built according to ISO 21287 standards. New barrel profile has two sensor slots on the three sides (Ø20 and Ø25 one slot) suitable for sensors 1580._, MRS._, MHS._ series housing, without need for adaptors. Versions with end stroke adjustable pneumatic cushioning are also available, allowing adjustments to deceleration and keeping the required overall dimensions according to ISO 21287. For fixing operation is possible to use the four threaded holes on the end covers, or screws in body holes, alternatively all the fixing devices of UNITOP RU-P/6-P/7 (Ø20 and Ø25) and ISO 15552 (from Ø32 to Ø100) series. Construction characteristics Operational characteristics Series 1500 - Compact cylinders according to standard ISO 21287 “ECOMPACT” Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device and aluminium piston) •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Our Technical Department will be glad to help. anodised aluminium aluminium alloy casting painted sintered bronze from Ø20 to Ø25 stainless steel from Ø32 to Ø100 C43 chromed (on request stainless steel) from Ø20 to Ø40 acetal resin (aluminium on request), Ø50 and Ø100 aluminium (with FPM seals, aluminium piston for all standard diameters) Standard: NBR oil resistant rubber, PUR piston rod seals (PUR or FPM seals available upon request) stainless steel plated zinc steel Body End cap Bearing piston rod Spring Fixing screws Piston rod Piston Seals Filtered air. No lubrication needed, if applied it shall be continuous. 10 bar -5°C - +70°C with standard seals (magnetic or non magnetic piston) -30°C - +80°C with PUR seals (magnetic or non magnetic piston) -5°C - +80°C with FPM seals (magnetic piston) -5°C - +150°C with FPM seals (non magnetic piston) Fluid Max. pressure Operating temperature Stroke tolerance, minimum and maximum spring loads and cushioning length Ø20 Ø25 Ø32 Ø40 Ø50 Ø63 Ø80 Ø100 Bore (mm) +1.5 / 0 mm +2 / 0 mm +2.5 / 0mm (mm) Stroke tolerance Minimum and maximum springs load (N) min. 10.8 16.7 19.6 25.5 44.1 44.1 63.8 107.9 max. 19.6 22.6 25.5 42.2 96.3 96.3 100.1 193.3 Cushioning length (mm) / 5 6.5 8 7.5 7.5 8 12
RkJQdWJsaXNoZXIy NzYzOTY1