Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Profile tube cylinders, non rotating Series 1325-1326-1345-1347 - Twin rod cylinders Pneumatic actuation 3 3 | 110 Series 1325-1326-1345-1347 - Twin rod cylinders Construction characteristics Other sealsN nBR 80 shore rubber Cushion bushings hardened aluminium Barrel RA=0.3-0.5 anodised aluminium Flange zinc plated steel Rod seal PUR Pistons vulcanized rubber block on steel core with incorporated permanent magnet, or without magnet for non magnetic version (plus spacer). Piston rod C43 chromed steel or stainless steel Front cap oxidised aluminium Rear cap UNI 5079 aluminium alloy casting Cushion adjustment screws nickel plated steel Operational characteristics Fluid filtered and lubricated air Pressure 10 bar Working temperature -5 °C ... +70 °C Please follow the suggestions below to ensure a long life for these cylinders: • use clean and lubricated air. • correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. • avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device). • evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.). Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Cushioning lengths Bore Ø 32 40 50 63 80 100 Front length mm 22 22 24 32 32 32 Rear length mm 28 32 32 40 44 50 Standard strokes Ø32: 25 - 50 - 75 - 100 - 150 - 200 mm Ø40: 25 - 50 - 75 - 100 - 150 - 200 - 250 mm Ø50: 25 - 50 - 75 - 100 - 150 - 200 - 250 - 300 mm Ø63: 25 - 50 - 75 - 100 - 150 - 200 - 250 - 300 - 350 mm Ø80: 25 - 50 - 75 - 100 - 150 - 200 - 250 - 300 - 350 - 400 - 500 mm Ø100: 25 - 50 - 75 - 100 - 150 - 200 - 250 - 300 - 350 - 400 - 500 mm On request are available strokes up to: 1000 mm Stroke tolerance (ISO 15552) Bore Stroke Tolerance 32-40-50 up to 500 mm +2 0 63-80-100 Load (N) Stroke (mm) Load Ø100 Ø80 Ø63 Ø40 Ø32 Ø50 150 100 50 0 100 200 300 400 500
RkJQdWJsaXNoZXIy NzYzOTY1