Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Flat profile cylinders 3 | 108 Series 1370 - 1371 - 1372 - 1373 - ECOFLAT Pneumatic actuation 3 Construction characteristics Operational characteristics 200 mm 320 mm Size 25 Size 32 - 63 Maximum standard strokes 2 Sections (cm ) 25 5,28 4,49 32 8,09 6,96 40 13,09 11,08 50 20,28 17,14 63 32,68 29,54 Maximum rod radial movement (°) 25 ±0.8 32 ±0.7 40 ±0.6 50 ±0.5 63 ±0.4 Maximum torque applicable on the piston rod (Nm): 25 0.8 32 1 40 1,3 50 1,8 63 2,1 The maximum torque values must also be accounted for while mounting accessories on the piston rod. Profiled tube has two "T" slots on the side hosting sensors 1580._, MRS._, MHS._. without adaptors. Two additional connections are also available on rear cover for cylinder feeding. Series 1370 - 1371 - 1372 - 1373 - ECOFLAT General Size 2 Out stroke (cm ) 2 In stroke (cm ) Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod; •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device and aluminium piston); •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Our Technical Department will be glad to help. aluminium anodised C43 chromed steel or stainless steel aluminium alloy anodised acetal resin, aluminium on request PUR PUR (FPM upon request) zinc plated steel NBR End caps Rod Barrel Piston Piston-seal Rod-seal Adjusting screw Shock absorber Filtered air. No lubrication needed, if applied it shall be continuous. 10 bar Fluid Max. pressure Operating temperature In order to calculate the theoretical force generated by the unit, both outstroke and instroke, it is necessary to use the following equation 2 FORCE(Kg) = Surface (cm ) x Pressure(bar) It is also necessary to remember that the theoretical force must be reduced by 10-15% in order to account for the unit internal friction. Size Rod radial movement Size Maximum torque -5°C - +70°C
RkJQdWJsaXNoZXIy NzYzOTY1