Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Compact cylinders Series 1500 - Short stroke cylinders Pneumatic actuation 3 3 | 132 Series 1500 - Short stroke cylinders Profiled tube has three "T" slots on the three sides hosting sensors 1500._, RS._, HS._. without adaptors and with adaptor code 1380.01F codes 1580._, MRS._, MHS._. A complete range of clamps makes them easy to install under any conditions. It is interesting to note that as these cylinders (from Ø32 to Ø100) have anchoring holes with the same lead and thread as those of series 1320 ISO 6431, they accept all mountings except for the intermediate trunnion. Construction characteristics Body oxidised aluminium Piston rod bushing oxidised aluminium Bottom plates oxidised aluminium Seals standard: NBR Oil resistant rubber, PUR Piston rod seals (HNBR or FPM seals available upon request) Pistons aluminium Piston rod C43 chromed steel (stainless steel for magnetic cylinder Ø20 and Ø25) Operational characteristics Fluid filtered air, preferably lubricated Pressure 10 bar Working temperature -5°C ... +70°C with standard seals magnetic or non magnetic piston -5°C ... +80°C with FPM seals magnetic piston -5°C ... +80°C with HNBR seals magnetic piston -5°C ... +120°C with HNBR seals non magnetic piston -5°C ... +150°C with FPM seals non magnetic piston Please follow the suggestions below to ensure a long life for these cylinders: • use clean and lubricated air. • correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. • avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device). • evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.). Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Standard strokes Double acting version Series 1501, 1504, 1511, 1514, 1515, 1516, 1517 and 1518: for all bores from 5 to 50 mm every 5 mm. Maximum suggested strokes: Ø20-Ø25: up to stroke 250 mm Ø32-Ø40: up to stroke 300 mm Ø50-Ø63: up to stroke 350 mm Ø80-Ø100: up to stroke 400 mm for strokes longer than 50 mm, please get in touch with our area sales rep. Single acting version Serie 1502, 1503, 1512 and 1513: for all bores from 5 to 10 mm. for strokes longer than 10 mm, please get in touch with our area sales rep. Series with non-rotating device: Ø20-Ø25: from 5 to 40 mm every 5 mm Ø32-Ø40: from 5 to 50 mm every 5 mm Ø50-Ø63: from 5 to 60 mm every 5 mm Ø80-Ø100: from 5 to 80 mm every 5 mm For longer strokes, please get in touch with the area sales rep. Minimum and maximum springs load for single acting version Bore 20 25 32 40 50 63 80-100 Min. load (N) 8.5 9.5 34 34 49 54 110 Max. load (N) 14.5 26 59.5 63.5 79 85 137
RkJQdWJsaXNoZXIy NzYzOTY1