Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Compact cylinders 3 | 127 Series 1500 - Short stroke cylinders 3 Pneumatic actuation Profiled tube has three "T" slots on the three sides hosting sensors 1500._, RS._, HS._. without adaptors and with adaptor code 1380.01F codes 1580._, MRS._, MHS._. A complete range of clamps makes them easy to install under any conditions. It is interesting to note that as these cylinders (from Ø 32 to Ø 100) have anchoring holes with the same lead and thread as those of series 1320 ISO 6431, they accept all mountings except for the intermediate trunnion. Construction characteristics Operational characteristics Series 1500 - Short stroke compact cylinders General Fluid Max. pressure Working temperature Body Rod Piston Rod bushing End cap Seals anodised aluminium C43 chromed steel (stainless steel for magnetic cylinder Ø20 and Ø25) aluminium anodised aluminium anodised aluminium Standard: NBR oil resistant rubber, PUR piston rod seals (HNBR or FPM seals available upon request) Filtered air. No lubrication needed, if applied it shall be continuous. 10 bar -5°C - +70°C with standard seals magnetic or non magnetic piston -5°C - +80°C with FPM seals magnetic piston -5°C - +80°C with HNBR seals magnetic piston -5°C - +120°C with HNBR seals non magnetic piston -5°C - +150°C with FPM seals non magnetic piston Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device) •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Our Technical Department will be glad to help. Standard strokes Series 1501, 1504, 1511, 1514, 1515, 1516, 1517 and 1518 for all bores from 5 to 50 mm every 5 mm. Series 1502, 1503, 1512 and 1513: For all bores from 5 to 10 mm. On request are available strokes up to 50 mm Ø 20 and Ø 25 from 5 to 40 mm every 5 mm. Ø 32 and Ø 40 from 5 to 50 mm every 5 mm. Ø 50 and Ø 63 from 5 to 60 mm every 5 mm. Ø 80 and Ø 100 from 5 to 80 mm every 5 mm. Double acting version Single acting version Type with non-rotating device: Ø 20 and Ø25 up to stroke 250 mm Ø 32 e Ø 40 up to stroke 300 mm Ø 50 e Ø 63 up to stroke 350 mm Ø 80 e Ø 100 up to stroke 400 mm On request are available strokes as follow:
RkJQdWJsaXNoZXIy NzYzOTY1