Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Compact cylinders Series 1500 Ecompact-S 3 Pneumatic actuation 3 | 147 Series 1500 Ecompact-S Based on the ECOMPACT series with piston rods and centring diameters according to ISO 15552 standard Construction characteristics Body anodized aluminium Piston rod bushings spheroid bronze on steel band with P.T.F.E. coat Seals standard: NBR Oil resistant rubber, PUR Piston rod seals (PUR or FPM on request) Springs stainless steel Pistons Ø32 and Ø40 acetal resin (aluminium on request) Ø50 and Ø63 aluminium (with FPM seals, aluminium for all of standard diameters) Piston rod C43 chromed steel (on request stainless steel) End caps aluminium alloy casting painted with brass centring bearing Fixing screws zinc plated steel Operational characteristics Fluid filtered and preferably lubricated air or not (if lubricated the lubrication must be continuous) Max. pressure 10 bar Working temperature -5°C ... +70°C with standard seals (magnetic or non magnetic piston) -30°C ... +80°C with PUR seals (magnetic or non magnetic piston) -5°C ... +80°C with FPM seals (magnetic piston) -5°C - +150°C with FPM seals (non magnetic piston) Use and maintenance Please follow the suggestions below to ensure a long life for these cylinders: • use clean and lubricated air. • correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. • avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device). • evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.). Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Stroke tolerance, minimum and maximum spring loads and cushioning length Bore (mm) Stroke tolerance (mm) Minimum springs load (N) Maximum springs load (N) Cushioning length (mm) Ø32 + 2 / 0 mm 19,6 25,5 6,5 Ø40 25,5 42,2 8 Ø50 44,1 96,3 7,5 Ø63 + 2,5 / 0 mm 44,1 96,3 7,5
RkJQdWJsaXNoZXIy NzYzOTY1