Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Rodless cylinders 3 | 196 Series 1605 Pneumatic actuation 3 Construction characteristics Caratteristiche di funzionamento The purpose of producing a rodless cylinder is to provide a space saving option over conventional cylinders. On a traditional rod type cylinder, the total space occupied with rod out is more than double the length of the cylinder, while with rodless cylinder it is little more than its stroke. Profiled tube allows mounting of sensors 1500._, RS._, HS._ and 1580._, MRS._, MHS._ on the two sides of carriage, by means of suitable brackets. Standard accessories include foot mounting brackets for installation on cylinder and caps, intermediate mounting brackets to give support to long stroke cylinders under load (over one metre), an oscillating coupling device for installation between the mounting plate and the load and on request, a very precise external movement device. Series 1605, Mechanically coupled General End covers Barrel Bands Mounting place Piston Guide blocks Cushion bearings Piston seals Other seals anodised aluminium anodised aluminium tempered stainless steel anodised aluminium acetal resin acetal resin aluminium special 80 shore nitril mixture, wear resistant NBR oil-resistant rubber Fluid Pressure Working temperature Max. speed Bores Max. strokes Filtered air. No lubrication needed, if applied it shall be continuous. 0.5 - 8 bar -5°C - +70°C 1.5 m/sec. (normal working conditions) Ø 25 - 32 - 40 - 50 - 63 6 m Use and maintenance This type of cylinder, due to its characteristics, has to be used within certain criteria. Correct use will give long and troublefree operation. Filtered and lubricated compressed air reduce seal wear. Verify that the load will not produce unforeseen stresses. Never combine high speed with heavy load. Always support the long stroke cylinder with intermediate brackets and never exceed the specified working conditions. If maintenance is required, follow the instructions supplied with the repair kit. For applications where a low smooth uniform operations speed is required, you must specify this on your purchase order so that we can use the proper special grease. Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •Please adequately evaluate the load involved and its direction, especially in respect to the moving carriage (also see tables for loads and admitted moments). •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device) •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO Vg32) for correct continued lubrication. Our Technical Department will be glad to help.
RkJQdWJsaXNoZXIy NzYzOTY1