Optyma-S e Optyma-Sc

Overalldimensionsand technical informationareprovidedsolely for informativepurposesandmaybemodifiedwithoutnotice Solenoid valves manifold Series 2200 "OPTYMA-S" Air distribution 10 Sub-base for 2 bistable valves Sub-base for 2 monostable valves Signals used for the single position 2 signals used for the first position 2 signals used for the second position 1 signal used for the first position 1 signal used for the second position 4 2 Sub-base configurations Total number of used signal Electrical connection The electrical connection is made using a 37 pin connector and can manage up to 32 electrical signals. Alternatively a 25 pin connector can be used which is suitable for up to 22 electrical signals. The distributions of the electrical signals between sub-bases achieved thanks to a dedicated electrical connector positioned in each sun-base which diverts the signals needed to operate the solenoid pilots of the valvemounted on the sub-base and passing unused signals forward to the next base. TheOptyma-S sub-bases are designed to carry two valves and are available in the following configurations: Sub-base for 2 bistable valves On the sub base for 2 bistable valves the first electrical signal is used to actuate the solenoid pilot on side 14 of the first position, the second signal is used to actuate the solenoid pilot on side 12 of the first position. Each sub base uses 4 electric signals. The same layout applies to the following position therefore the third signal is used to actuate the solenoid pilot on side 14 of the second position and the fourth signal is used to actuate the solenoid pilot on side 12 of the second position. The remaining signals are transferred downstream. On a bistable sub base it is possible to mount both bistable or monostable valves (in the second case 1 electrical signal for each valve is wasted). This solutions enables the user to change the manifold layout without the need to re-configure the output correspondence on the PLC. The use of bistable sub-bases reduces the maximum number of valves that can be mounted on the manifold: If the 37 pole connector is used the maximum number of valves is 16 If the 25 pole connector is used the maximum number of valves is 10. Sub-base for 2monostable valves On the sub base for 2 monostable valves the first electrical signal is used to actuate the solenoid pilot on side 14 of the first position, the second signal is used to actuate the solenoid pilot on side 12 of the second position. Each sub base uses 2 electric signals. The remaining signals are transferred downstream. On a monostable sub base it is possible to mount only monostable valves (shoud a bistable valve be mounted on a monostable sub base it will not be possible to actuate the solenoid pilot on side 12). This solutions enables the user tomaximise themanifold lay out using all the electrical signals available. If the 37 pole connector is used themaximumnumber of valves is 32 If the 25 pole connector is used themaximumnumber of valves is 22 Note: Monostable valves, which are fitted with only one solenoid pilot can be mounted on both monostable or bistable sub bases. Bistable valves ,5/3; 2x3/2;2x2/2, which are fitted with 2 solenoid pilots and therefore always use two electrical signals must always bemounted on bistable subbases. Additional exhaust and air supplymodules: The Additional exhaust and air supply module is fitted with a dedicated electrical connector which does not use any electric signal but simply carries forward all signals which have not been used by the valvesmounted before it. This enables its use in any position of themanifold.