Optyma-S e Optyma-Sc

Overalldimensionsand technical informationareprovidedsolely for informativepurposesandmaybemodifiedwithoutnotice DeviceNet Module Air distribution Solenoid valves manifold 1 7 Series 2200 "OPTYMA-S" - Serial system DeviceNet module is directly integrated on Optyma-S solenoid valves manifold via a 37 poles connector, normally used for multipolar cable connection. Optyma-S solenoid valves connected to node must be PNP equivalent (final 02 in ordering code). The node can be easily installed also on solenoid valves manifold already mounted on equipment. Module can manage up to 32 solenoid valves, and, in the same time, a max number of 4 Input modules 5222.08S. DeviceNet module recognizes automatically the presence of the Input modules on power on. Regardless of the number of Input modules connected, themanagable solenoid valves are 32. Node power supply ismade by aM12 4Pmale circular connector. The separation between node 24 VDC Power supply and outputs 24 VDC allows to switch off the outputsmaintaning powered the node and inputs, if present. Connection to Bus DeviceNet is possible via 2 M12 5P male - female circular connectors; these two are connected in parallel and according to DeviceNet Specifications Volume I, release 2.0. Transmission speed can be set by 3 dip-switches. The node address can be set by 6 dip-switches using BCD numeration. Themodule includes an internal terminating resistance that can be activated by a dip-switch. General: 5422.32S 2 1 3 4 Scheme / Overall dimensions and I/O layout : M12 4P MALE MAX 32 OUT 52 POWER SUPPLY connector PIN 1 2 3 4 DESCRIPTION +24 VDC (NODE & INPUTS) NC GND +24 VDC (OUTPUTS) 99 63 Ordering code Technical characteristics 2 1 4 3 5 1 2 5 4 3 M12 5P MALE M12 5P FEMALE NETWORK connectors Optional CAN external positive supply (Dedicated for supply of transceiver and Optocouplers, if galvanic isolation of the bus node applies) PIN SIGNAL DESCRIPTION 1 CAN_SHLD Optional CAN Shield 2 CAN_V+ 3 CAN_GND Ground / 0V / V- 4 CAN_H CAN_H bus line (dominant high) 5 CAN_L CAN_L bus line (dominant low) Model Specifications Case Power supply connection Power supply voltage Node consumption (without inputs) Power supply diagnosis PNP equivalent outputs Maximum current for each output Maximum output number Max output simultaneously actuated Network connectors Baud rate Addresses, possible numbers Max nodes in net Bus maximum recommended length Bus diagnosis Configuration file IP protection grade Temperature range 5422.32S DeviceNet Specifications Volume I, release 2.0. Reinforced technopolymer M12 4P male connector (IEC 60947-5-2) +24 VDC +/- 10% 30 mA Green PWR LED +24 VDC +/- 10% 100 mA 32 32 2 M12 5P connectors male-female Type A (IEC 60947-5-2) 125 - 250 - 500 Kbit/s From 1 to 63 64 (slave + master) 100 m at 500 Kbit/s Green + Red LED LED Available from our web site: http://www.pneumaxspa.com IP65 when assembled From 0° to +50° C Power supply Outputs Network