Optyma-S e Optyma-Sc

Overalldimensionsand technical informationareprovidedsolely for informativepurposesandmaybemodifiedwithoutnotice 8 Input/Output Module Air distribution Solenoid valves manifold 9 Series 2200 "OPTYMA-S" - Accessories 1 4 3 3-4 21 5-6 28 25 26 29 27 30 31 32 ... 19-20 21-22 23-24 17-18 Please note: I/O modules don’t allow to connect any additional valvesmanifold after them. Please note: Optyma 32-S solenoid valve manifolds manage up to 32 signals. If the manifold uses more than 24 signals the I/O module will manage only the remainder. Connections that are not managing useful signals will remain unconnected. Attention: No more additions are possible Attention: Output only Attention: Output only Attention: Only one more I/O module can be added. Not connected Attention: Signal Not connected GND Connected Through line Connected Attention: Output only Attention: Signal Not connected GND Connected Attention: No more additions are possible Attention: Output only M ulti-pole connector pin 37 poles Connettor Connettore 37 poli Serial node Outlet Pin Serial node Outlet Pin Serial node Outlet Pin 3-4 21 5-6 31 28 29 32 30 ... 22-23 24-25 26-27 20-21 3-4 Module 1 21 5-6 7-8 12 9 10 13 11 14 15 16 3-4 21 5-6 7-8 Module 1 12 9 10 13 11 14 15 16 Module 2 20 17 18 21 19 22 23 24 3-4 21 5-6 7-8 Module 1 12 9 10 13 11 14 15 16 Module 2 20 17 18 21 19 22 23 24 3-4 2 1 5-6 31 28 29 32 30 ... 22-23 24-25 26-27 20-21 M ulti-pole connector pin PIN DESCRIPTION 1 NOT CONNECTED 4 SIGNAL 3 GND Serial node Outlet Pin Input Module With this kind of control the I/O module can only be used as an output. Pin 1 of each connector is not connected. The output voltage will be 0.7V lower than that applied to Pin 4 of the connector. The maximum output current for each output is 100mA. Te correspondence between control byte and each single output depends on how many electrical signals are used by themanifold and by the relative position of the I/Omodule. B) Control via fieldbus: Not connected