Technical information are provided for informative purpose only and can be subject to change without prior notice 149 LOCATING Automotive Catalogue Pin package installation to the tool The pin package can be installed by one of its three mounting surfaces, using dowels and screws according to its datasheet. The tightening torques to be set are: M6 10 N m / 7.37 lb·ft M8 25 N m / 18.43 lb·ft Use the key support surfaces, where available. Always use all the bores on the mounting pattern. The clamp is warranted for 3 mln cycles in correct operating conditions No lubrication. No preventive maintenance. The pin packages do not require any specific adjustment. The rod alignment as well as the anti-rotation are set in the manufacturing department and do not require any adjustment on-site. External cleaning with non-corrosive detergents is required: cleaning interval depends on the ambient conditions as well as on the frequency of use. 3 MLN CYCLES Electronic sensor ES001 is used for all pin packages’ sizes and series. Stepless adjustment of the connector: unscrew the tightening screw and set the connector in the required position, then secure the screw with 5 N m / 3.68 lb·ft. To replace the sensor, remove the M5 screw and assemble a new one by tightening the same screw with 5 N m / 3.68 lb·ft. Technical features Operating voltage 10-30 VDC Voltage drop ≤ 2 V Load current ≤ 100 mA Current consumption ≤ 25 mA Short-circuit protection protected Protection rating IP68 Operating temperature –0 °C +50 °C Storage temperature –25 °C +60 °C Electromagnetic compatibility EN 60947-5-2:2007 + A1:2012 Power supply indication green LED Open position indication yellow LED Closed position indication red LED 1 4 3 2 Semplified diagram (PNP) Open Close Not engaged Yellow Green Brown + Black Blue White LOAD LOAD Red Engaged
RkJQdWJsaXNoZXIy NzYzOTY1