Technical information are provided for informative purpose only and can be subject to change without prior notice 171 External stops, guides and shock absorbers Using external stops, guides and shock absorbers is not a recommended procedure, as it may interfere with the correct functioning of the unit. All Pneumax power pivots are equipped with an integrated hard stop for the linkage, which guarantees an accurate and repeatable closed position. By using additional external stops or guides which prevent the power pivot to completely reach its end stroke, the correct functioning of the linkage will be jeopardized and it will invalidate any warranty of the unit. In case external stops or guides are installed by the customers, they must not interfere with the correct functioning of the unit. In case external guides are used, they must not generate any interference higher than 0,05 mm on their support. In case the load conditions require shock absorbers to be installed, it is strongly recommended that they do not reach their end-stroke before the power pivot is toggle locked. Stocking conditions Warehouse temperature: from -20°C to 50 °C Relative humidity: 10% to 90% Info For any further information, do not hesitate to contact us at Orientation of the supply ports The orientation of the supply ports on any power pivot can be easily and quickly modified, simply by untightening the 4 tie rods and rotating the cylinder block. Air must be disconnected during this procedure. Make sure to comply with the tightening torque specifications shown in the previous pages “power pivots installation to the tool”. automotive@pneumaxspa.com Automotive Catalogue PIVOTING
RkJQdWJsaXNoZXIy NzYzOTY1